Please remove the striking plate by removing the one screw

Please remove the handle by removing the two screws

Use a pencil to mark the placing of the fixing plate. The marks should be 35 mm from the top of the bottom sash as show in the image

Predrill holes for the screws

Fix the L-brackets onto the motor as shown

Please mark where to predrill the holes on the frame

Please predrill holes to fix the motor

Please fix the motor

Please start by fixing the plate onto the sash and then fix the chain to the plate

This is what a correctly installed motor looks like

Turn to the control unit. Remove the white top cover

Take the motor cord and remove covering, so the brown and white wires are visible. Fix the wires into the respective slots on the small unit as shown

Please find a piece of cord (not included in box) and remove covering, so 3 wires are shown. Place the three wires into the 3 holes as shown. The colors are not important, but the colors on the small unit should correspond with later work on the switch

Place the small unit in the control unit as shown

Prepare to insert the 3 wires into the switch. Please place the three wires in the switch as shown. Please compare the wire colours to the split in the actual control unit. Please split the middle wire into two.

Fix the wires as shown. The electrical opener can now be tested. When you push both buttons on the switch at the same time the window will stop. You can now fix the control unit and the switch onto the wall.